Amprobe WT-80 Manual De Uso página 18

The reading is not changed
• If the status is in "HOLD", release the status.
• If the measurement is in MTC, input temperature value.
Slow response
• Clean and re-calibrate the probe.
• Replace with a new probe.
Wrong real time
• The wrong real time display will not affect the measurement. Contact
the distributor to purchase battery and acquire replacement procedures.
Error code
E02 Reading is under the lower limit
E03 Reading is over the upper limit
E04 The original data error result in this error
E12 Factory calibration data error
Solution: Re-start meter might solve this error
E13 Slope or offset value of pH probe is out of the range
E31 Measuring circuit failure
Solution: Re-start meter might solve this error
E32 Memory IC failure
12