Parkside PBS 600 A1 Instrucciones De Utilización Y De Seguridad página 41

Connection:
j
Push the adapter for external vacuum extraction
12 into the adapter port
use the reducer piece
13
into the adapter for external vacuum extraction
j
Slide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
12
if used.
Removal:
j
Pull off the dust extraction device hose.
j
Pull off the adapter for external vacuum extrac-
tion (with the reducer piece
12
operation
Q
Switching on and off
Q
When operating the belt sander you can select
between intermittent or continuous operation mode.
To switch on intermittent operation mode:
j
Press the on / oFF switch
To switch off intermittent operation mode:
j
Release the on / oFF switch
To switch on continuous operation mode:
j
Press the on / oFF switch
pressed, then press the locking knob
To switch off continuous operation mode:
j
Press and then release the on / oFF switch
Selecting the correct rotational
Q
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel even whilst the sander is running.
1
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the best
speed by carrying out a small test. The following
table lists some recommended values to help you
determine the optimum speed.
All manuals and user guides at all-guides.com
9 . If it is necessary to
, push the reducer piece
.
12
with the reducer piece ,
13
, if used).
13
3
.
3
.
, and keep it
3
4
.
3
.
Preparing for use / operation
Material / type of Softwood
work
Coarse finish 60
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation high (5-6)
speed
Material / type of Hardwood
work
Coarse finish 60
(Grit grade)
Fine finish (Grit grade) 180
Preselected rotation high (5-6)
speed
Material / type of Chipboard
work
Coarse finish 60
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation high (5-6)
speed
Material / type of Removing paint /
work varnish
Coarse finish 60
(Grit grade)
Fine finish (Grit grade) ––
Preselected rotation high (5-6)
speed
Material / type of Sanding varnish
work
Coarse finish 150
(Grit grade)
Fine finish (Grit grade) 320
Preselected rotation low (1-2)
speed
GB/MT 41