Publicidad
Step 14
å
Carefully stand your unit upright.
å
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL
PINS (1R) into the hole locations of your choice in the ENDS (A and B). Set the
ADJUSTABLE SHELF (D) onto the METAL PINS.
å
Push two DOOR STOPS (4I) into the holes in the TOP (K).
å
Before fastening the DOOR to your unit, be sure the mounting screw is against
the stops as shown in the right diagram. If it isn't, loosen the adjusting screw and
mounting screw to slide it against the stops. Then tighten the mounting screw.
å
Fasten the LEFT DOOR (H) to the LEFT END (B) as shown in the lower diagram.
Use the screws in the HINGES. You should start each SCREW a few turns before
completely tightening any of them.
å
Fasten one PULL (189K) to the LEFT DOOR (H). Use two BLACK 9/16" LARGE
HEAD SCREWS (1S).
å
Repeat this step for the RIGHT DOOR (J).
å
See the next step for DOOR adjustments.
189K
BLACK 9/16" LARGE HEAD SCREW
(4 used for the PULLS)
www.sauder.com/service
H
1R
(4 used)
1S
K
B
D
2R
The DOOR STOP is
adjustable. If needed, turn the
DOOR STOP until it allows
the DOOR to evenly close.
426909
17
Stop
Mounting
screw
Adjusting
screw
Hinge
A
(2 used)
4I
Page 19
Publicidad
