Publicidad
Control Panel/Panneau de commande/Panel de control
Lock Button:
NOTE: It is strongly recommended to use this feature to avoid any unexpected/unintentional
movement.
1. Press this button to lock the touch-screen. This will prevent accidentally engaging the controls after the
desired height has been set. Press the button again to unlock the touch-screen.
2.To change between inches and centimeters, press and hold the Lock button for 5 seconds.
Display:
1. The display will indicate the height of the desk (inches) . After five seconds without input, the digital
readout will automatically fade away.
2. When the desk has reached the lowest setting, the display will indicate "bot".
3. When the desk has reached the highest setting, the display will indicate "top".
4. Touch and hold one of the memory buttons (H1-H3) for 3 seconds when the desk is at the desired height
in order to save it as a memory preset. The desk will automatically return to the set height when the
corresponding memory button is touched.
5. Touch and hold the
desk is at the lowest height setting when "bot" is displayed.
6. Touch and hold the
desk is at the highest height setting when "top" is displayed.
USB Ports:
There are 3 USB ports suitable for charging devices with 2.4A charging power requirement (or lower).
The USB ports will pause charging temporarily when the height of the desk is being adjusted and the motor
is in use.
Timer Button
The time is displayed in minutes and the point will not appear. For example, the readout will display 105 or
90, as opposed to 10.5 or 9.0.
1. Touching the timer button will cause the digital readout to blink. Use the Up button
the timer settings: 00, 10, 15, 30, 45, 60, 75, 90, 105, 120. Use the Down button
timer settings: 120, 105, 90, 75, 60, 45, 30, 15, 10, 00. Touch the timer button again to confirm and start the
countdown.
2. When the timer function is activated, the digital readout will display the timer in descending minutes.
For example, 120, 119, 118, 117......05, 04, 03, 02, 01, 00). At that time, if the desk's height is adjusted, the
readout will show the height and return to the timer afterwards.
3. When the countdown is finished, the desk will beep 5 times continuously in 3 total successions and
remain stationary.
OPERATION/UTILISATION/OPERACIÓN
button to lower the desk and release when it arrives at the desired height. The
button to raise the desk and release when it arrives at the desired height. The
5
3 USB Ports(2.4A for each port)
Trois ports USB (2,4 A pourchaque port)
3 puertos USB(2.4 A para cada puerto)
Lock Button
Bouton de verrouillage
Botón de bloqueo
to cycle through
to cycle through the
B264
Publicidad
