MeisterCraft MAS 144 LIO Manual De Instrucciones página 43

MC-5451150-Bedien-0908.qxd
from the charger after charging. If the
charger and battery become warm
during charging, this is normal and does
not indicate a malfunction.
TIP! It is recommended to
control the charging process
using an electric clock timer!
Torque setting
The power screwdriver has a 24-level
torque setting to protect the drill and bit
holders or chuck from damage. By
turning the knob on your screwdriver
you can set it to the required speed,
from 1 (light driving) to max. (heavy
driving/drilling
correct torque for the work in hand.
8 – Operation
The chuck (1) fits all commercially
available screwdriver and drilling bits
with a diameter of up to 10 mm.
On tools which can rotate clockwise or
counterclockwise the chuck is always
mounted with a left-hand-thread bolt.
Before the chuck is changed, this bolt
must be undone through the chuck from
the front. Left-hand-thread screws can
be undone only by turning them
clockwise. The tool has a quick-action
chuck.
This enables attachments to be changed
in manual operation quickly and without
using a chuck key.
Switching ON and OFF is done by
pressing and releasing the ON/OFF
switch (3). During operation the working
light (9) is on.
19.09.2008 16:04 Uhr
All manuals and user guides at all-guides.com
). Always select the
Seite 43
9 – Mode of operation
Electronic speed control
The electronic speed control (2) allows
you to steplessly adapt the speed to the
work in hand.
• Switch (1) pressed lightly = low
speed, for undoing tight screws.
• Switch pressed right down =
maximum possible speed, for drilling.
ATTENTION! Do not allow the
motor to come to a stop while
drilling or driving screws under load!
Left and right-hand rotation
The direction of rotation is set by means
of the slide switch (4) above the operating
switch.
PLEASE NOTE! Change direction
of rotation only when the motor
is stationary!
• Inserting screws: Move switch to „R".
• Inserting screws: Move switch to „L".
• Safety position: Switch in middle
position; when the slide switch is in
this position, the tool cannot be
started, e.g. during breaks in work or
when changing drill or screwdriver bits.
43