Lubricating The Chain Bar; Maintenance At The End Of The Work; Special Maintenance; General - CAMPAGNOLA ATTA.0000 Manual De Uso

MAINTENANCE
6.1.5

Lubricating the chain bar

The oil flow on the chain (5) has been pre-set by the manufacturer (see par. 2.1)
Always check the oil level in the air compressor lubricator glass. The lubrication takes place automatically.
Use Campagnola BIG FLU or FUDY FLU oil for lubricating the chain (5).
WARNING !
The lack of lubrication may cause seizing of chain (5).
6.1.6

Maintenance at the end of the work

When the working cycle is over, before storing the tool for a prolonged period, it is recommended to put few drops of
diesel or anti-oxidizing spray lubricant into the extension pole handle, making the tool idle for few seconds.
This will avoid any residues due to air moisture.
WARNING !
Remove the side protection (3) periodically and eliminate the cutting residues, which might prevent the chain (5)
from moving perfectly.

6.2 Special maintenance

6.2.1

General

Before any maintenance operation:
Wear protective gloves
Disconnect the tool from the compressed air hose.
WARNING !
Before carrying out any maintenance operation, disconnect the tool from the compressed air hose.
Any special maintenance operation shall be performed in a Campagnola S.r.l. Authorised Service Point.
6.2.2

Cleaning the chain bar and the lubrication holes

Clean these parts often, especially before using the tool.
Remove the chain (5) and clean the bar drive (6).
Clean the lubrication holes.
! " # $ % $ &' (') !&
Pag.29