Crosscall X-COMM Manual De Instrucciones página 17

Idiomas disponibles

communication

Press and hold one of the 2 PPT buttons (3 or 14) throughout the conversation. You will hear a

beep to indicate that the communication channel is open. Let go of the button when you have

finished. A beep sound will let you know when it is closed.

DISCREET MODE

Briefly press 2 times the «On/Off & Discreet Mode» button (9) to switch off the speaker and the

LEDs. The sound can still be heard via the 3.5mm jack. Briefly press 2 times the same button again

to reactivate the speaker and the LEDs. A «Discreet Mode Off» voice prompt will tell you that the

speaker is activated.

adjusting the volume

Press the volume + or – button (8) once to increase or decrease the volume by one level (level 0

= 0%: no sound - level 10 = 100%: maximum volume).

Pressing and holding the volume + or – button (8) will continuously decrease (down to 0%)

or increase (up to 80%) the sound volume of the X-COMM. The remaining 20% of volume are

available by pressing the volume + (8) button twice more.

Each time the volume changes, you will hear a beep. This is a low-volume signal that gradually

increases as the volume of the X-COMM increases. At level 8 (80%), the beep is accompanied

by a «Be careful» voice prompt. At level 10 (100%), the beep is accompanied by a «Maximum

level» voice prompt.

emergency button

Press and hold the emergency button (6) for 3 seconds. This activates a beep sound followed by

a «Emergency» voice prompt.

Bluetooth®

The Bluetooth® system is permanently activated. This is used for pairing with a smartphone

up to 2 metres away. Bluetooth® switches off automatically when the X-COMM is connected to

a smartphone via the USB C/X-LINK™* cable. The optimal transmission distance between the

X-COMM and the smartphone is up to 10 metres.

battery and indicators

The X-COMM battery is designed to last for 20 hours of intensive use with the sound level at

maximum volume (60% standby, 20% transmission and 20% reception). The battery takes

about 2 hours to reach 100% charge.

The X-COMM has LED lights (11) which indicate the status of the battery:

• 1 lit bar indicates a battery charge of 25% or less