Publicidad
Idiomas disponibles
Idiomas disponibles
USING YOUR TOTAL CRUSHING® PITCHER
IMPORTANT: Review all warnings on
pages 4–6 before proceeding.
IMPORTANT: As a safety feature, if
the pitcher and lid are not properly
installed, the timer will display "- --"
and the motor will be disabled. If this
happens, repeat step 5. When the
pitcher and lid are properly installed, the
program buttons will illuminate steadily,
indicating the appliance is ready for use.
TIP: If the Stacked Blade Assembly is
not fully seated, you will not be able to
install and lock the lid.
TIP: To learn more about the unit's
programs, refer to page 10.
NOTE: Pre-set programs have pauses
and changes in speed throughout
the cycle.
NOTE: DO NOT add ingredients before
completing installation of the Stacked
Blade Assembly.
NOTE: The pitcher can only be installed
in one orientation. The handle must be
positioned on the front-right corner of
the motor base to operate the appliance.
NOTE: Smart Vessel Recognition can
detect which container is on the motor
base. Only the functions available for
a particular container will illuminate on
the touchscreen.
12
ninjakitchen.com
1 Place the unplugged motor base on a
clean, dry, and level surface such as a
countertop or table. Press downward on
the motor base to adhere the suction
cups to the work surface. Ensure the
motor base is connected to power.
2 Lower the Total Crushing Pitcher onto the
motor base. The handle should be aligned
slightly to the right and the pitcher should
be oriented so the LOCK symbols are
visible on the motor base. Then rotate the
pitcher clockwise until it clicks into place.
3 Exercising care, grasp the Stacked Blade
Assembly by the top of the shaft and
place it onto the drive gear inside the
pitcher. Note that the blade assembly
will fit loosely onto the drive gear.
4 Add ingredients, making sure to not
exceed the Max Fill line marked on the
side of the pitcher.
5 Place the lid on the pitcher, aligning
the triangle symbol located on the lid
with the triangle symbol located on
the pitcher's handle. Press down on
the handle until it clicks into place. The
triangle symbols MUST be aligned for
the lid to lock onto place and the unit
to operate. When the unit is connected
to power and the container is correctly
locked into the motor base, press the
Power symbol to turn unit on. The
available program buttons will illuminate
and the unit will be ready for use.
6 If using a pre-set program, first select
the program that best suits your recipe.
The pre-set feature will automatically
stop the unit at the end of the program.
To pause the appliance at any time, press
the currently active button a second
time. Reference page 10 for program
descriptions.
7 If not using a pre-set program and
ingredients have reached your desired
consistency, stop the appliance by
releasing the manual speed button,
and wait for the appliance to come to a
complete stop.
8 To remove the pitcher from the motor
base, turn the pitcher counterclockwise
and lift it up.
9 To pour out thinner mixtures, ensure the
lid is locked in place, then open the pour
spout cap.
10 For thicker mixtures that cannot be
emptied through the pour spout, remove
the lid and Stacked Blade Assembly
before pouring. To remove the lid, press
the RELEASE button and lift the handle.
To remove the blade assembly, carefully
grasp it by the top of the shaft. The
pitcher can then be emptied.
11 Unplug the unit when finished. To release
the motor base, place your hands
underneath both sides of the motor base
and gently pull the unit up and towards
you. Refer to page 22 for storing
instructions.
ninjakitchen.com
13
Publicidad
