Jacto GM-2 Manual Del Operador página 10

1)
• Insert the hose through the clamp, fit it securely into the tank outlet, and
tighten the clamp.
1)
tank outlet
clamp
hose
• Insert the other end of the hose through the fairing and screw it back onto
the tank.
ATTENTION!
Do not over-tighten any parts.
• Next, insert the hose through the clamp into the dosage feeder and tighten
the clamp.
1)
hose
clamp
dosage
feeder
4.2. Adjusting the strap
The equipment tank has an anatomical shape, providing greater comfort to the
operator. With a simple strap adjustment, the operator can position the equip-
ment correctly on his back.
• Pull the straps down to adjust them as needed.
10/26
2)
2)
2)
A
pull strap
down
5. Operating the equipment
ATTENTION!
Do not operate your equipment if parts are missing.
Replace any defective parts before use. Misusing the
equipment can result in malfunction and personal injury.
ATTENTION!
When operating the spreader, wear personal protective
equipment (PPE), such as boots, gloves, protective
eyewear, and a face mask.
5.1. Using the equipment
Follow the steps below to operate your equipment correctly:
• Remove the tank lid.
• Insert the strainer and pour the product to be used in the application.
• Remove the strainer and close the tank lid correctly to avoid waste.
To apply:
1. Hold the spreader as shown in figure 1.
2. Press the spreader at the desired location for the dosage to be
released (figure 2).
3. Repeat these steps until the end of the application.
B
strap lock