Descargar Imprimir esta página

Metra 99-3012G Instrucciones De Instalación página 7

Ocultar thumbs Ver también para 99-3012G:

Publicidad

Idiomas disponibles

Idiomas disponibles

Connections to be made
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (sold separately) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard
this harness. If it will be used, please refer to the ASWC-1 instructions for radio
connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.
Note: The relay attached to the 3012 harness is only for audible turn signal
clicks. No extra steps are required to retain this, so leave it as-is.
99-3012G
(Cont)
Continue to installing the interface
®
Installing the interface
With the key in the off position:
1. Connect the 16-pin harness with stripped leads, and the 3012 harness,
into the interface.
2. Connect the 3012 harness to the vehicle.
3. Locate the factory antenna connector in the dash and complete all necessary
connections to the radio. Metra recommends using the proper mating adapter
from Metra.
4. Before using the kit it must be initialized.
Attention! If the interface loses power for any reason, the following steps will
need to be performed again. Also, if installing an ASWC-1 connect it after you
initialize and test the interface/radio, with the key in the off position.
a. Turn the key (or push-to-start button) to the ignition position and wait until
the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
b. Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
5. Secure the completed assembly into the dash using the factory screws.
Note: Before assembling the dash, refer to the "Adjusting the interface"
section on the following page.
6. Snap the radio trim panel over the completed assembly, and then reassemble
the dash in reverse order of disassembly.
7

Publicidad

loading