Watts LF007 Serie Instrucciones De Instalación página 19

Launch D6000 Utility Software to select, configure, and open the host serial communications
port where the module is connected.
In the Connection Type field (upper left), select Serial Port.
Using the Quick Setup drop-down list (lower left), select D6100 7CH Voltage Input.
In the Serial Port Settings field (upper right), select the proper communications port and then
click Settings.
If the "Default*" line is connected to ground, then select 9600 baud rate, no parity, eight data
bits, one stop bit, and RTS Only flow control. The Tx and Rx delays can be left in their default
state. Otherwise, adjust the communications settings to match the settings in the connected
module. Click Open Port to complete the serial port configuration process.
19