Dreame V11SE Manual Del Usuario página 7

How to Use
EN
Function Introduction of Display Screen
Note: If you need to pay attention to any abnormality during the use of the product,
a prompt will appear on the screen. You should follow the instructions on the screen
to keep the performance normal.
Language Settings
Set the display prompt language by following the instructions below:
Press and hold for 3 seconds to enter the language selection interface. Click
to scroll through the language list, select a language, and then press
hold for 3 seconds to save your setting.
Note: If there is no operation for more than 5 seconds, it will automatically exit from
the language setting interface, and the display information will be off.
10
Electronic Lock/Reset Filter
• Click to switch between working modes
• Press and hold for 1.5 seconds to enter the
filter reset interface
Battery Level Monitor Ring
•
Blue: Battery level is more than 20%
• Red: Battery level is less than 20%
Gear Switch/Language Setting
• Click to switch between Eco Mode,
Med Mode, and Turbo Mode
• Press and hold for 3 seconds
to enter the language setting
interface
and
How to Use
Cleaning Mode
There are two working modes for the vacuum, which can be selected based on your
own needs.
Mode 1: Discontinuous Cleaning Mode
Press and hold the switch of the vacuum to power it on, and release it to stop
immediately.
Mode 2: Continuous Cleaning Mode (Electronic Lock)
Click the electronic lock key to switch to Continuous Cleaning Mode, and then briefly
press the on/off switch to leave the vacuum cleaning in Continuous Cleaning Mode.
Use the electronic lock to free your finger from fatigue caused by holding the switch.
Note:
• In this mode, briefly press the on/off switch to suspend the operation or start
again, and the working mode of the vacuum will not change.
• Click the electronic lock again to quit the Continuous Cleaning Mode.
EN
11