Congratulations on your purchase of a Sunn Model T ampli-
fier. The all-tube Model T features a 2 channel switchable
preamp with individual tone controls and an "arena / club"
switch allowing the selection between 100 watt or 25 watt
power outputs. The footswitch offers the ability to remote-
ly switch on and off the effects loop and to select between
the two preamp channels. The effects loop is an all tube
series type with separate send and return controls for each
A. IN - Plug your guitar in here.
B. VOLUME - Adjusts the volume level of channel 1.
C. TREBLE - Adjusts the amount of increase or decrease in
the high frequency content of channel 1.
D. BASS - Adjusts the amount of increase or decrease in the
low frequency content of channel 1.
E. MIDDLE - Adjusts the amount of increase or decrease in
the mid frequency content of channel 1.
F. GAIN - Adjusts the gain/distortion level in channel 2.
G. TREBLE - Adjusts the amount of increase or decrease in
the high frequency content of channel 2.
H. BASS - Adjusts the amount of increase or decrease in the
low frequency content of channel 2.
I. MIDDLE - Adjusts the amount of increase or decrease in
the mid frequency content of channel 2.
J. VOLUME - Adjusts the volume level of channel 2.
A. POWER SWITCH -
Turns the AC power
on and off.
B. FUSE - The fuse
will help to pro t e c t
the amplifier fro m
electrical faults. If a
fuse blows, replace it
only with one of the
same type and rating
(refer to the specifica-
tion page). If the amplifier repeatedly blows fuses, it should
be taken to an authorized Fender service center.
S
u
n
n
®
S
u
n
n
®
F
r
o
n
t
P
a
F
r
o
n
t
P
a
P
o
w
e
r
I
n
p
u
t
/
P
o
w
e
r
I
n
p
u
t
/
M
o
d
e
l
T
M
o
d
e
l
T
channel. In addition, the main amp out and extension amp
in jacks on the rear panel allow chaining multiple Model T
units together. The magnetic interference reducing chassis
eliminates unwanted noise and radio interference. The cab-
inet is constructed from hand-selected woods, employing
rugged corner corner joinery for enduring reliability and is
covered in genuine Tolex
n
e
l
C
o
n
t
r
o
l
s
n
e
l
C
o
n
t
r
o
l
s
K. CHANNEL SELECT LED - This LED does not illuminate
when channel 1 is active. When this LED illuminates RED,
channel 2 is active. CH SELECT - This push-push button
switches between channel 1 and channel 2. When this but-
ton is in, channel 2 is active. Using the footswitch (includ-
ed) overrides the channel select switch.
L. PRESENCE - Adjusts the ultra-high frequency response
of the amplifier.
M. STANDBY - When the power switch and this switch are
on, your Model T is ready to perform. In the standby posi-
tion, power is supplied only to the tube filaments and sound
will not come out of the amp. Using the standby switch dur-
ing short breaks eliminates tube warm-up time and will
increase tube life.
N. PILOT LIGHT - This pilot jewel illuminates when the
Model T is receiving power. Should this bulb burn out, turn
off and unplug the amplifier, unscrew the pilot jewel and
replace the lamp with a type T47 bulb.
O
u
t
p
u
t
F
u
n
c
t
O
u
t
p
u
t
F
u
n
c
t
C. LINE CORD - The Model T is equipped
with a grounding type IEC supply cord to
reduce the possibility of shock hazard. Be
sure to connect it to a grounded AC recep-
tacle in accordance with the frequency and
voltage ratings listed on the rear panel of the
amplifier under input power.
D. ARENA / CLUB - Switches the output
power of your Model T between 100W and
25W operation. When the switch is in the
arena position, the amplifier's output is at
100W useful for larger venues. When the switch is in the
club position, the amplifier's output is at 25W.
4
®
for long lasting good looks.
i
o
n
s
i
o
n
s