PNI Hunting 400C PRO Manual De Usuario página 26

EN
Waterproof
Dimensions
Weight
APP
TROUBLESHOOTING
Photos do not capture subject of interest
1. Check the "Sensor Level" (PIR sensitivity) parameter setting. For warm
environmental conditions, set the Sensor Level to "High" and for cold weather
use, set the sensor for "Low".
2. Try to set your camera up in an area where no heat resources are in the camera's
field of view.
3. In some cases, set the camera near water will make the camera take images with
no subject in them. Try to aim the camera over ground.
4. Try to set camera on stable and immovable objects, i.e.: large trees.
5. At night, motion detector may detect beyond range of the IR illumination.
Reduce distance setting by adjusting sensor sensitivity.
6. Rising sun or sunset can trigger sensor. Camera must be reoriented.
7. If person/animal moves quickly, it may move out of the camera's field of view
before photo is taken. Move camera further back or redirect camera.
Camera stops taking images or won't take images
1. Please make sure that the SD card is not full. If the card is full, camera will stop
taking images. Or user can turn on Cycle Recording to avoid such problem.
2. Check batteries to make sure that alkaline, or NiMH AA batteries left power is
enough for camera to work.
3. Make sure that the camera power switch is in the "On" position and not in the
"Off" or "Setup" modes.
4. When GPRS function is on, there will be around 1 minute interval for camera
to send out photo before camera shooting the next photo. Turn off the GPRS,
camera can shoot photos continuously.
5. Please format the SD card with camera before using or when camera stops
taking images
Night vision flash range doesn't meet expectation
1. 4pcs AA batteries is not able to support camera night vision ability; please install
8 pcs AA batteries;
2. Please check to make sure that batteries are fully charged or left power is enough;
26
IP66
148 x 117 x 78 mm
448g
IOS & Android
User manual