Publicidad
5.2 INSTALLATION: Wall Mount (External Junction Box)
STEP 1: Disconnect power supply.
Remove (2) plastic plugs. Remove
inserted (2) M5*12 screws, (2) M5 Flat
washers and mounting plate.
STEP 4: Connect the wires with
(3) P3 Wire Nuts. Refer to the same
Wiring Diagram as Wall Mount
(Built-in Junction Box).
6. Turn ON Power at the Breaker
After connecting power supply, the lights will turn on and your Starfish Security Floodlight Camera will make a sound to
indicate that it's in pairing mode.
TROUBLESHOOTING
1. Check your power source.
2. Check electrical connections.
3. Check that the motion sensor is working properly.
7. Connection Preparation
Please install the Starfish Security Floodlight Camera in an area that has adequate Wi-Fi signal to ensure the best
product performance.
Camera
NOTE: Please refer to Starfish User Guide for detailed product pairing instructions. This product requires a 2.4GHz Wi-Fi
connection for proper operation.
© Copyright 2022 Satco Products, Inc. 1/23, v2.5
STEP 2: Attach junction box on
the wall (not supplied).
STEP 5: Secure fixture onto mounting
plate with inserted (2) M5*12 screws,
(2) M5 Flat washers and plastic plugs.
Router
3
STEP 3: Fix mounting plate
and gasket onto junction box
with (4) #10-1inch Screws.
STEP 6: Check fixture and
connect power supply.
Smartphone
Publicidad
