Publicidad
Position
Excess moisture will travel throughout your home, in the same way that cooking smells waft to
every room in the house. For this reason, the dehumidifier should be positioned, so that it can
draw this moist air towards it from all over the home.
Alternatively, if you have a serious problem in one area you can begin by positioning the
dehumidifier close to this area and later moving it to a more central point.
When positioning the dehumidifier, ensure that it is placed on a level surface and that there is a
minimum of 10 cm (4") of space on either side of the unit to allow for efficient airflow.
If you move the unit, it should first be switched off and the water tank emptied.
We do not recommend the use of an extension lead, so please try to ensure that the unit is
sufficiently close to a fixed mains socket. If it is necessary to use am extension lead, please
ensure the diameter of the wires of the cable is at least 1 mm2.
When the dehumidifier is in operation, outside doors and windows should be closed when
necessary for most efficient use.
Operation
1. Plug the unit into a correct mains socket. (Please refer to the rating label for correct
voltage/frequency.)
2. Turn ON/OFF button & humidity controller clockwise
away from the OFF-position. As soos as the present
humidity-level is passed, the compressor will start to
work. The indicator will turn into green.
3. Set the ON/OFF-button & humidity controller to the
required humiditylevel level (the intensity of humidity
extraction is increased clockwise). When the required
humidity is reached, the humidifier wil stop automaticly.
For continuous working, set the humidistat to position
'MAX'.
4. To turn off the unit, turn ON/OFF button back to 'OFF'.
Unplug always after use.
Drainage
While the water tank is full, the compressor will stop for self-protection and the water full
indicator will turn into red.
To move the water tank, pull it out squarely from the unit.
After empting the water tank, place the water tank into space. Make sure it is properly
positioned, in order for the 'water full' sign to go out and your dehumidifier is operating.
Please note: in case, the water tank has not been positioned well, the water full indicator will
turn into red. The equipment does not work.
Continuous drainage
When the dehumidifier is operated at very high humidity levels, the water tank will require more
frequent drainage. In this situation, it may be more convenient to set the unit up for continuous
drainage with the following procedures:
1. Pull out the water tank.
2. Connect the drain hole with water tube of inner diameter: 9mm. Please note: the water
tube is not supplied with the unit. Lead the tube down into a drain or a big container.
10
Publicidad
