Publicidad
Idiomas disponibles
Idiomas disponibles
T-C display, to zero.
• If no acti on takes place for around 4 minutes, the
computer switches off automati cally.
BEFORE ASSEMBLY
Never remove the rati ng plate and any possible warn-
ings!
1. Check the items supplied for completeness (see
the "Items Supplied" chapter) and possible transport
damage. If you fi nd any damage to the components,
do not use them (!), but contact our customer service
department.
2. Lay out all parts carefully on a fl at fl oor. To be on
the safe side, place a protecti ve fi lm. or blanket un-
derneath the parts to prevent any damage to delicate
surfaces.
3. Before using the device, remove all packaging ma-
terials and any labels that may be on the device and
are used for protecti on during transportati on or for
adverti sing.
ASSEMBLY
Follow these assembly instructi ons step by step to
prevent any errors during set-up and
subsequent use:
1. Screw the feet onto the bott om of the device enclosure. Use the fastening material
supplied with the device to do this. The smaller support bar should be at the front (be-
low the tension knob).
2. Turn the pedals ti ght on the pedal mounts using the spanner which is supplied. Make
sure that the markings L (left ) and R (right) on the pedals and mounts match. The right
pedal (right-hand thread) is ti ghtened in the clockwise directi on.
The left pedal (left -hand thread) is ti ghtened in the anti clockwise directi on.
ADJUSTING THE PEDAL STRAPS
There is the opti on of adjusti ng the strap size on the pedal.
To do this, unscrew the cross-head screws on the pedals
and adjust the straps to the size you want. Then ti ghten the
Publicidad
