Selco BOX BASIC RI 3000 EtherNet/IP Instrucciones De Uso página 61

Stored welding spots selection configurations: the selection of the stored welding spots is directly defined by this combination
of digital inputs.
BYTE N° 11
BYTE N° 11
BYTE N° 10
BYTE N° 9
BYTE 11 BYTE 11 BYTE 10
BIT 0x20 BIT 0x10 BIT 0x80
0 0
0 0
0 0
0 0
0 1
0 1
0 1
0 1
1 0
1 0
1 0
1 0
1 1
1 1
1 1
1 1
BYTE N° 9
BYTE N° 9
BYTE N° 9
BYTE N° 9
BYTE N° 9
BYTE N° 9
BYTE N° 9
Consult the section "Set-up parameter 400" (Genesis ... repair manual)
BIT N° 0x20 The combination of these first 4 digital processes is summarised in the fol-
BIT N° 0x10 lowing table:
BIT N° 0x80
BIT N° 0x80
BYTE 9
BIT 0x80
0 0 FP-RC configuration
0 1 Retrieval of stored welding spots enabled
1 0 Retrieval of synergetic curves in MIG MAG Short Spray Arc
1 1 Retrieval of synergetic curves in Pulsed MIG MAG
0 0 Retrieval of synergetic curves in T.MAP Rapideep
0 1 Retrieval of synergetic curves in T.MAP Quickpulse
1 0 Not used
1 1 Not used
0 0 Retrieval of synergetic curves in Welding Procedure Specifications (WPS) in MIG
MAG Short Spray Arc
0 1 Retrieval of synergetic curves in Welding Procedure Specifications (WPS) in
Pulsed MIG MAG
1 0 Not used
1 1 Not used
0 0 Not used
0 1 Not used
1 0 Not used
1 1 Not used
BIT N° 0x40
BIT N° 0x20
BIT N° 0x10 CODING: the combination of these digital signals makes it possible to
BIT N° 0x08 determine the synergetic curve or the required welding spot.
BIT N° 0x04
BIT N° 0x02
BIT N° 0x01
61