Publicidad
Idiomas disponibles
Idiomas disponibles
6. Install Weather Stripping (ENERGY STAR models only)
If AC is Blocked by Storm Window
Models RAC-WK05/06/08/10/12
Storm window
1-1/2"min
frame or other
(38 mm)
obstruction.
Removing AC From Window
•
Turn AC off , and disconnect power cord.
•
Remove sash seal from between windows, and unscrew sash lock.
•
Remove screws installed through top rail and side panel frames.
•
Slide the accordion panels into the rails to close.
•
Keeping a fi rm grip on the air conditioner, raise the sash and carefully remove.
•
Be careful not to spill any condensate while lifting unit from window. Store parts WITH air conditioner.
Page 20
Fig. 11
Fig. 12
SASH
Board thickness
as required, for
proper pitch to rear,
along entire
sill. Fasten with nails
or screws.
In order to minimize air leaks between the
room air conditoner and the window opening,
trim the weather stripping to the proper
length, peel off the protective backing and
plug any gaps if needed (Fig. 11).
Add wood as shown in Fig. 12, or remove
storm window before air conditioner is
installed.
If storm window frame must remain, be sure
the drain holes or slots are not caulked or
painted shut. Accumulated rain water or
condensation must be allowed to drain out.
User Manual
Publicidad
