Publicidad
Idiomas disponibles
Idiomas disponibles
o
35-48
C
o
48-50
C
o
50-55
C
o
55-60
C
o
60-65
C
ATTENTION!
WATER AT A TEMPERATURE OVER 50°C CAUSES SERIOUS
BURNS. ALWAYS CHECK THE WATER TEMPERATURE BEFORE
USE.
IGNITION & WATER OUTLET
•
Open the water valve, there will be spraying signal shown on the screen. When the
fan whirls, the igniter turns on and flame shows, hot water will come out accordingly.
The display shows the setting temperature of outlet water.
•
When using, water outlet flow and temperature can be adjusted in the same method
as mentioned. After opening water and starting, Setting the range of 35-48°C, above
48°C, only press down key (Child lock function to prevent burns). If want to set the
temperature higher than 48°C, turn off the hot water faucet and then press the button
to warming.
•
When the water valve is open, but the switch stays at OFF position, the water heater
will stop working, and only cold water runs out. If hot water is needed, you should
press ON button.
•
Turn off the water valve and water heater stop working, but the fan still blows the
combustion chamber for several seconds. The machine will show the temperature
set last time when opening the water valve next time.
•
Every time after using the gas water heater, the gas valve must be closed, and AC
power must be cut.
Attention:
•
If the water valve is open before the water heater is switched on, the gas water heater
will into the protective mode, and the buzzer sounds. Please close the water valve
then.
•
It might take several trial ignitions after installation or the first use after recharging the
gas tank to push out all the air remained in the gas pipe (G30).
•
The temperature shown on the screen is the setting temperature, while the outlet
water temperature differs according to the length of pipes and different seasons.
Therefore, please refer to the actual outlet water temperature.
•
If hot water flow excesses the water heater's capacity, the water may not be hot
enough.
Please turn down the water flow accordingly
•
Every time the water heater starts working, please pay attention to the setting
temperature on the display and be careful not to being scaled.
•
In order to avoid being scaled, whenever using the water heater, you must test the
water temperature with your hand before showing.
•
When the gas water stops working and the display shows error codes, please close
the water valve and reopen. Or press the on/off button until the machine is off, and
o
1
C
Push button
o
2
C
Push button
o
5
C
Push button
o
5
C
Switch OFF the machine and then push
button for 5 sec
o
5
C
Push button
for 5 sec
51
Publicidad
