Presetting The Access Commands - JVC KD-LX50 Manual De Instrucciones

STOP
PLAY

Presetting the Access Commands

You can store the frequently-used operations into the Access Commands and register your
voice to make the System execute the Access Commands.
• You can store the following operations into the Access Commands;
– Selecting the source (CD and External component).
– Selecting the frequencies (FM and AM).
– Selecting the CDs in the CD changer.
Before you start...
• Set "VOICE WORD" to "USER."
Without setting it to "USER," you cannot preset the Access Commands.
• Notice the following;
– You can store up to 12 Access Commands (12 operations and voice commands into
memory).
– Each voice command must be within 3 seconds long.
– You can register any word you want; however, if it is too short (ex: "Pops"), the System
may not recognize it correctly.
Registering procedure (for the first Access Command)
EXAMPLE:
Storing an operation of "selecting the FM station of 89.5 MHz," and registering words "Jazz
89" as your Access Command to that operation into Access Command number 14.
1- -
1 , 4
1
Select the User Word mode by following steps 1 to 4 on page 27.
1 Press and hold SEL (Select) for more than 2 seconds so that one of the PSM
items appears on the display.
2 Press
3 Press – to select "USER WORD."
4 Press SEL again to finish the setting.
30
1-
3
¢ or 4
repeatedly until "VOICE WORD" appears on the display.
3,7
1-
2
4
Voice remote