Assembly Instructions - Sears Kenmore CSV Go S4015 Manual De Uso Y Cuidado

Aspiradora inalámbrica de vara
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before assembling the vacuum cleaner, check the PACKING LIST (Page 2). Use this list to
verify that you have received all the components of your new Kenmore CSV Go Cordless
Stick Vac.
1. Insert the hand vacuum into the top of
the wand until you hear a click.
WARNING
Before charging make sure the unit is
turned OFF.
1. Insert the charging adapter plug into the
charging port on the side of the hand
vacuum base.
2. Plug the adapter into a wall outlet. The
battery indicator will begin to pulse
blue.
The battery requires approximately 4 hours
of charging to regain full capacity. While
the unit is charging, the battery indicator
ring will pulse blue. When the battery is

ASSEMBLY INSTRUCTIONS

Click
CHARGING
- 9 -
2. Insert the bottom of the wand into the
motorized nozzle until you hear a click.
fully charged, the battery indicator will
show a continuous blue light, and turn off
after 15 minutes.
NOTE:
If the battery indicator does not
illuminate when charging, ensure that the
charging adapter is plugged in properly to
the wall outlet and the charging port on the
hand vacuum.
For better battery performance, it is
recommended to charge the unit when
the battery indicator shows a continuous
yellow light during operation, and remove
the charging adapter from the unit after the
battery is fully charged.
Never charge the batteries in temperatures
above 104°F (40°C) or below 39.2°F (4°C).
It is normal for the charger to become
warm when charging.
Click
Battery Indicator

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido