Publicidad
Idiomas disponibles
Idiomas disponibles
• Align hole on the sheet metal with hole on the left side of the metal frame, insert the screw through
holes in the two side metal frame and sheet metal from inside of metal frame and gently tighten the
FR
• Repeat the other sheet metal on the right side of the metal frame.
• Put the water container in the metal frame. The round side of the two sheet metals must hold on the
ES
upper edge of the water container.
PT
• Loosen the transport safety knob to unlock the motor/cutting unit.
FITTING THE WATER PUMP
• Lift the machine carefully with at least two persons into the water container. Push the water pump in
IT
the holder of the water container.
• Make sure that the pipe and pump cord are without bending or twisting. Make sure that the pipe and
the pump cord can still move freely and are not pressed together or squeezed.
EL
• Now place the pre-mounted machine carefully with at least two persons to the frame.
FITTING THE CONTINUOUS TRACKS GROUPWARE
PL
remove the foam blocks.
• Retilt the machine motor to original position and tighten two
UA
• Loosen the transport safety knob to slide the motor away from the circumrotate board. Loosen and
remove four cross-screws (two on the circumrotate board and two on the motor), fasten the
continuous tracks groupware to intended positons using four cross-screws.
RO
FITTING THE ANGLE GUIDE
• Slide the angle guide into the groove of the guide.
EN
• Fix the angle guide in the desired position by tighten the two clamping screws.
FITTING THE CUTTING LENGTH LIMITER KNOB
• Tighten two cutting length limiter knobs to the screw on the heading rail. Limited rise must run inside
of the heading rail.
7. OPERATION
ON/OFF SWITCH
WARNING! Before starting:
• Ensure that there are no visible defects.
• Ensure that there is nothing in the work area that may hamper the work to be performed.
• Ensure that there is sufficient cooling water.
• Ensure that the guard is correctly mounted.
• Ensure that no one other than the operator is in the working area.
• For safety reasons replace the tool if it is found to be damaged in any way.
• To switch on, press the "1" on the on/off switch.
• Before you begin cutting, wait until the cutting wheel has reached maximum speed and wait for the
cutting disc to get wet.
• To switch off, press the "0" on the on/off switch.
MAKING 90° CUTS
• Loosen the angle guide locking knob and set the angle to 0° degrees, then tighten the locking knob
again in order to secure the angle guide.
• Then loosen the clamping screw and push it to the required position.
• Now move the machine head to the rear using the handle.
CAUTION! Do not position the angle guide in line with the cutting
wheel line or else it could be cut during operation.
board) and tilt the machine motor to
129
Publicidad
