Publicidad
Idiomas disponibles
Idiomas disponibles
• Place a tile against the guide and the angle guide.
• Switch on the machine.
• Important: Wait until the cooling water has reached the cutting wheel.
• Using the handle, move the machine head forward slowly and smoothly through the tile.
MAKING 45° DIAGONAL CUTS
• Set the angle guide to 45°.
• Make the cut.
MAKING 45° LONGITUDINAL CUTS ("JOLLY CUTS")
• Loosen two Fixing knobs for mitre cut.
• Tilt the guide rail to the left to 45° on the angle scale.
• Make the cut.
CUTTING LENGTH LIMITATION
With the two cutting length limiter knobs and you can limit the possible movement of the motor/
cutting unit.
• Release both limiter knobs and adjust the limiter knobs to the desired size. The scale on the guide will
help with this.
EXCHANGING THE CUTTING DISC
• Pull out the power plug.
• Let the machine cool down.
• Fix the motor/cutting unit with the xing screws and the plastic beam.
• Loosen the four cross-screws of the cover for the cutting disc and open the cover.
• Attach the big angle wrench to the hex nut and place the other angle wrench on the motor shaft and
hold.
• Using the big angle wrench to loosen the hex nut in the direction of rotating of the cutting disc.
(caution: Left-hand thread).
• Install the new cutting disc in reverse order and tighten.
• Important: Pay attention to the direction of rotation of the cutting disc.
8. MAINTENANCE
WARNING! Remove the plug from the power socket before
carrying out any adjustment, servicing or maintenance.
Cleaning and maintenance overview
Prior to every start
What
Check mains cable, mains plug, supply cables,
cold water pump and cutting wheel for damage.
Regularly, depending on conditions of
use
What
Check all screwed connections and tighten them
if necessary.
Clean dust and splinters from the machine.
How?
Visual inspection.
How?
Visual inspection.
Blow dust and splinters away with compresses air,
or use a brush.
130
FR
ES
PT
IT
EL
PL
UA
RO
EN
Publicidad
