Assembly And Adjustments - Hitachi Koki CW 40 Manual De Instrucciones

ASSEMBLY AND ADJUSTMENTS

ESTIMATED ASSEMBLY TIME 15~20 MINUTES
ASSEMBLE STAND (FIG. A)
1. Unpack all parts and group by type and size. Refer
to the parts list for correct quantities.
2. Attach one short upper support (1) to top of leg (2)
using one bolt (3) and nut (4).
NOTE:
●
Align detents in stand leg with support brackets
to ensure proper fit.
●
Do not tighten bolts until stand is properly
aligned (see step #8 before tightening).
3. Attach other end of short upper support to top of
another leg using one bolt and nut.
4. Attach one short bottom support (5) to center of
each leg using bolt (3) and nut (4). This completes
the front frame section.
5. Assemble rear frame section in exactly the same
manner.
6. Join front and rear frame assemblies using two long
upper supports (6) and two long bottom supports
(7), bolts and nuts.
7. Insert foot pad (8) into bottom of leg. Repeat for
each leg.
8. Place stand on level surface and adjust so all legs
are contacting the floor and are at similar angles to
the floor, and detents in stand leg align with support
brackets, then tighten all bolts.
NOTE: To avoid rocking, tighten all bolts.
Fig. A
3
4
6
7
8
●
●
●
MOUNTING THE SCROLL SAW (FIG. A, B)
1. To mount your scroll saw to the stand, position the
2. Matching the holes (2) in the scroll saw base with
3. Secure the stand and saw using the hex head bolts
4. Tighten all four nuts.
NOTE: Do not over tighten nuts holding saw to
Fig. B
9
10
9
10
1
11
12
1
5
2
– 11 –
WARNING
The stand is designed only for using with scroll
saw.
Do not climb, sit or stand on the stand assembly.
Do not use the stand on uneven or unstable
surface.
leg stand (1) on a firm, level surface.
the holes in the leg stand, place the scroll saw on
the stand.
(9), flat washers (10), sleeve (11) and nuts (12)
provieded.
stand. This may damage this saw base.
2
12
English