HON END BOOK SHELF Instrucciones De Montaje página 4

Illustration 8A
Arrow
Shelf
assembly
Illustration 8B
Arrow
Brace panel
Minifix
bolt
Illustration 9
Bottom
4 OF 7
END BOOK SHELF
Brace panel
Minifix
cam
Minifix
bolt
RH
Minifix
cam
Shelf
assembly
LH
Glide
Glide insert
8. Refer to Illustration 8A for right handed units and 8B
for left handed units. Attach brace panel to end panel/
shelf assembly by inserting minifix bolts, attached to
brace panel, into holes drilled into side of end panel/
shelf assembly.
With arrows facing brace panel, install seven minifix
cams into right end panel and one minifix cam into bot-
tom side of each shelf.
Use the Phillips screwdriver to tighten minifix cams.
Turn minifix cams clockwise to tighten.
9. Refer to Illustration 9. Position bottom, on cardboard or
carpeted surface, so four-corner hole pattern faces up.
Use the rubber mallet to install glide inserts (from hard-
ware pack) into each hole.
Thread a glide (from hardware pack) into each glide
insert. Turn glides clockwise until glides are flat against
glide inserts. (NOTE: leave glide at front of bottom
shelf extended approximately
tighten glide. Fully tightening glide will cause glide
insert to pull out of bottom shelf.)
After glides are fully installed, flip assembly over.
/ ". Do not fully
1
4
2420956500_E
www.hon.com