LONCIN GR2300iS El Manual Del Propietario página 24

5
ALTERNATING CURRENT(AC)CONNECTION
NOTICE
WARNING
TIP: Make sure to ground (Earth) the generator. When the electric device is
earthed, always the generator must be earthed.
1.Start the engine.
2.Turn the ESC to "ON".3.Plug in to AC receptacle.
4.Make sure the AC pilot light is on.
5.Turn on any electric devices.
TIP: The ESC must be turned to"OFF" before increasing engine speed to
rated rpm.
Most motorized appliances require more than their electrical rating for

startup.When an electrical motor is started, the overload
indicator (red) may come on.This is normal if the overload indicator(red) goes off
within 4 seconds. If the overload indicator (red) stay son,consult your generator
dealer.
lf the generator is connected to multiple loads or electricity consumers, please

remember to first connect the one with the highest starting current.And last
connect the one with the lowest starting current.
lf the generator is overload, or if there is a short circuit in a

connected appliance, the overload indicator (red) will go ON. The overload
indicator (red) will stay ON, and after about 4 seconds,current to the connected
appliance(s) will shut off,and the output
Be sure any electric devices are turned off before
plugging them in.
Be sure all electric devices including the lines

and plug connections are in good condition
before connection to the generator.
Be sure the total load is within generator rated

output.
Be sure the receptacle load current is within

receptacle rated current.
21
Inverter Generator Owner's Manual
Operation