Publicidad
Idiomas disponibles
Idiomas disponibles
7. ASSEMBLY
Before any work on the power tool, remove the battery.
The battery must be charged before first use.
Inserting the battery into the machine (Fig. B)
Ensure that the exterior of the battery is clean and dry before connecting to the charger or machine.
1. Insert the battery (2) into the base of the machine as shown in Fig. B.
2. Push the battery further forward until it clicks into place.
Removing the battery from the machine (Fig. B)
1. Push the battery unlock button (3)
2. Pull the battery out of the machine like shown in Fig. B.
Fitting and removing drills or screwdriver bits (Fig. A)
The drill chuck (7) is suitable for drills and screwdriver bits with round shaft as well as hexagonal
shaft.
1. Hold the machine firmly with one hand.
2. Open the drill chuck (7) by rotating the chuck with your other hand in clockwise direction until
it is opened far enough for the bit to slide in.
3. Insert the shaft of the drill or screwdriver bit.
4. Tighten the drill chuck again by firmly rotating the chuck (7) counterclockwise.
5. Check if the bit is centered well by shortly activating the machine´s on/off switch.
8. OPERATION
Adjusting the gears (Fig.A)
Never switch gears when the motor is running, this will damage your machine.
Never put switch in the middle between both positions, this will damage your machine.
The machine has 2 drill speeds, which can be adjusted by sliding the gear switch (8) forward
or backwards. The number on the gear switch (8) shows which position is chosen.
• Position 1: For slow drilling, large drilling diameter or screw driving. The machine has high
power at a low speed.
• Position 2: For fast drilling or small drilling diameter.
Adjusting the direction of rotation (Fig. A)
• Set the direction switch (9) to position in order to drive screws or to use it for drilling.
• Set the direction switch (9) to position in order to remove screws.
Switching the machine on and off (Fig. A)
The on/off switch (5) is used for activating the machine and adjusting rotation speed.
• Pressing the on/off switch (5) will activate the machine, the further the switch is being pushed,
the faster the drill will turn.
• Releasing the on/off switch (5) will stop the machine.
7
Publicidad
