Publicidad
Idiomas disponibles
Idiomas disponibles
• Move the direction reversing switch (9) to the middle position to lock the movement of the on/
off switch.
Adjusting the torque (Fig. A)
The machine has 21 different torque settings and a special drill mode to set the power being trans-
mitted to the chuck. By rotating the torque adjustment ring (6), screws can be driven to a predeter-
mined depth, which is ideal for repetitive work. The higher the number, the more torque will be
transmitted.
• Select a low setting for small screws or soft work material.
• Select a high setting for large screws, hard work materials and when removing screws.
• You should preferably choose a setting as low as possible when driving screws. Select a higher
setting if the motor slips before the screw is fully tightened.
• For drilling, turn the torque adjustment ring (6) to the setting for drilling (
it counterclockwise.
Ensure that the direction switch (9) is always set to
The machine is equipped with electronic overload protection function. When the machine
gets overloaded it will shut down automatically. When this happens, please wait for a few seconds
to let the overload protection reset itself.
9. MAINTENANCE
Before cleaning and maintenance, always switch off the machine and remove the battery pack from
the machine.
Clean the machine casings regularly with a soft cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Remove very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such as gasoline, alcohol, ammonia, etc. Chemicals
such as these will damage the synthetic components.
10. ENVIRONMENT
Faulty and/or discarded electrical or electronic apparatus have to be collected at the appro-
priate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC for Waste Electrical and Electronic Equipment and
its implementation into national right, power tools that are no longer usable must be collected
separately and disposed of in an environmentally friendly way.
during drilling.
8
) by fully turning
Publicidad
