Technical Specifications; Declaration Of Conformity; Battery Charging; Dust/Chip Extraction - stayer BHL112BK Manual De Instrucciones

gb

TECHNICAL SPECIFICATIONS

= Battery
= Voltage
= Battery power
= Battery charging time
= No load speed
rpm
= Tightening torque
= Percussions
ipm
= Wood drilling capacity
= Steel drilling capacity
= Stone drilling capacity
= Weight
= Sound power level
= Sound pressure level
= Vibration
The values given are valid for nominal voltages
[U]230/240 V-50/60 Hz - 110/120 V - 60Hz. For lower
voltage and models for specific countries, these
values can vary.

DECLARATION OF CONFORMITY

The undersigned: STAYER IBERICA, S.A.
With address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: +34 91 691 86 30
CERTIFIES
That the machine:
Type: Cordless drill/screwdriver
We declare under our sole responsibility that this
product is in conformity with the following standards
or standardized documents: EN 60745-1, EN 60745-
2-2, EN 55014-1, EN 55014-2, EN 61000-3-2, EN
61000-3-3, according to EU Regulations 2006/42/EC,
2014/30/EU.
Ramiro de la Fuente
Director General
January 5, 2019
3_ASSEMBLY

BATTERY CHARGING

Use only the battery chargers listed on the
accessories page. Only these battery chargers are
matched to the lithium ion battery of your power tool.
Note: The battery is supplied partially charged. To
ensure full capacity of the battery, completely charge
the battery in the battery charger before using your
power tool for the first time.
The lithium ion battery can be charged at any time wi-
thout reducing its service life. Interrupting the charging
procedure does not damage the battery.
Do not continue to press the On/Off
switch after the machine has been
automatically switched off. The battery can
be damaged.
To remove the battery 5, press the battery unlocking
button 9 and pull the battery out of the power tool
toward the rear. Do not exert any force.
The battery is equipped with a NTC temperature control
which allows charging only within a temperature range
of between 0º C and 45º C. A long battery service life
is achieved in this manner.
Observe the notes for disposal.
CHANGING THE TOOL
Before any work on the machine (e. g.,maintenance,
tool change, etc.) as well as during transport and
storage, set the rotational direction switch to the
centre position. Unintentional actuation of the On/Off
switch can lead to injuries.
Open the keyless chuck 2 by turning in rotation
direction , until the tool can be inserted. Insert the tool.
Firmly tighten the collar of the keyless chuck 2 by hand
in rotation direction . This automatically locks the drill
chuck.
The locking is released again to remove the tool when
the collar is turned in the opposite direction.

DUST/CHIP EXTRACTION

Dusts from materials such as lead-containing coatings,
some wood types, minerals and metal can be harmful
to one's health. Touching or breathing-in the dusts
can cause allergic reactions and/or lead to respiratory
infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in connection
with woodtreatment
preservative). Materials containing asbestos may only
be worked by specialists.
– Pro v ide for good ventilation of the working place.
– It i s recommended to wear a P2 filterclass respirator.
Observe the relevant regulations in your country for
the materials to be worked.
- 18 -
(not aply to 202-204 models)
additives (chromate, wood