GE Profile 24 CustomStyle Manual Del Propietário página 23

Inserting the door panels.
Loosen the Top Trim on the Freezer and Fresh Food Doors.
Using a T-20 Torx driver, loosen the two screws
attaching the Top Trim about 1/4" (6 mm).
Insert the Freezer Panel and Fresh Food Panel.
Lift the Top Trim up 1/4" (6 mm) and carefully
push the freezer panel in until it slides into the slot
behind the door handle. Push the filler panel
(required with some door panels) in behind the
decorator panel. Repeat for fresh food panel.
Insert the Bottom Panel (for models with a dispenser and/or a Refreshment Center)
Carefully push the panel in until it slides into the
slot behind the door handle. Push the filler panel
(required with some door panels) in behind the
decorator panel.
Tighten the two screws on the Top Trim to 30 in-lbs torque.
Top Trim Screws
Cut-Out
Top
Freezer
Panel
Tape Liner
Bottom
Freezer
Panel
Side Trim
If your model has a dispenser and/or a
Refreshment Center, this step only applies
to the top panels.
Cut-Out
Fresh
Food
Panel
Side Trim
23