wad CW001 Instrucciones De Uso página 6

Conical lever
· The cutting machine is equipped
with an adjustable conical lever that
changes the height of your cut.
· When the lever is in the highest
position, the blades will give the
tightest cut.
· Pushing the lever down gradually
increases the cutting length.
10
Cleaning and maintenance
Blade alignment:
· The blades are greased and aligned before leaving
the factory.
· They should be realigned if they have been removed
for cleaning or replacement.
· To realign the blades, simply match the teeth of the
upper and lower blades, point for point. The end of the
upper blade teeth should be approximately 0.5 to 1 mm
behind the lower blade. Compare the blades of your
cutting machine with the drawing.
· If the blade alignment is incorrect, add a few drops of
oil to the blade, switch on the cutting machine for a
few moments, switch it off and unplug it. Loosen the
screws slightly and adjust the alignment. Tighten the
screws after the blade is aligned.
Cleaning of the blades:
· Clean the blades
with the cleaning
brush provided.
Blade maintenance:
· To keep your clipper in
top condition, the blades
should be oiled every few
haircuts.
· For proper oiling, the
unit must be held so
that the blades are in
a downward position.
With the machine blade
in operation, pour 2 or 3
drops of oil on the
upper blade.
11