Manuales relacionados para Truper ROTO-1/2N7-2
Resumen de contenidos para Truper ROTO-1/2N7-2
- Página 1 Manual Hammer Drill 1.2 Hp 1/2” Power Chuck Applies for: Code Model 15202 ROTO-1/2N7-2 ROTO-1/2N7-2 Read the user’s manual thoroughly CAUTION before operating this tool.
- Página 2 Manual before using the tool. Parts Assembly Keep this manual for future references. Start Up The illustrations in this manual are for reference only. They might be different from the real tool. Maintenance Notes Authorized Service Centers Warranty Policy ROTO-1/2N7-2 ENGLISH...
- Página 3 Technical Data ROTO-1/2N7-2 Code 15202 Description Hammer Drill Chuck 1/2” Voltage Frequency 220 V 50 Hz / 60 Hz Current Power 1.2 Hp Drilling Capacity Metal: 0.51” | Concrete: 0.51” | Wood: 0.98” Speed 1: 0 - 1 200 RPM...
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instruction listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Safety Warnings for Drills and Hammer Drills Select the Right Bit While Operating the Hammer Drill CAUTION • Select the right bit for the material. • Hold the tool using both the main handle and the This reduces the risk of severe injuries and makes the auxiliary handle if supplied with the tool.
- Página 6 Parts Depth Mechanical Impact-Rotation Control Rod Speed Selector Selector Chuck Continuous Rotation Speed Operation Button Selection Auxiliary Control Button Handle Handle Switch Power Cable Power Cord Protector Chuck Chuck Key Holder Assembly 1. Turn the auxiliary handle in a Depth clockwise direction while released Control Rod so that the opening in the mount...
- Página 7 Start Up Bit Fitting Chuck • Put the bit into the chuck until it stops. Fasten with the chuck key and tighten the chuck alternatively into each of the orifices. WARNING • Clean burr and any other foreign object from the bit and the chuck. Otherwise, the bit cannot be tight and could cause personal injuries.
- Página 8 Start Up Adjusting Auxiliary Handle And Depth Control Rod • To set the auxiliary handle into the right position to operate as hammer drill turn the auxiliary handle as indicated in the figure. When the auxiliary handle mount is loose, turn it into the desired position.
- Página 9 Notes ENGLISH...
- Página 10 Notes ENGLISH...
- Página 11 Authorized Service Centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800 018-7873 to get information about the nearest Service Center.
- Página 12 . Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257 Stamp of the business.