Manuales relacionados para Truper ROTO-1/2N8
Resumen de contenidos para Truper ROTO-1/2N8
- Página 1 Manual Hammer drill 1 Hp 1/2” Power Chuck Applies for: Code Model 15683 ROTO-1/2N8 ROTO-1/2N8 Read this manual thoroughly CAUTION before using the tool.
- Página 2 Contents CAUTION Technical data Power requirements To gain the best performance of the tool, prolong the duty life, General power tools safety warnings make the Warranty valid if necessary, and to avoid hazards Safety warnings for drills and hammer drills of fatal injuries please read and understand this Manual before Parts...
- Página 3 Technical data ROTO-1/2N8 Code 15683 Description Hammer drill Chuck 1/2” Voltage 127 V Frequency 60 Hz Current 5.4 A Power 1 Hp Functions Drill - Hammer drill Speed 0 - 2 000 RPM Strokes per minute 0 - 32 000 BPM Boring capacity Concrete: 1/2”...
- Página 4 General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references.
- Página 5 Safety warnings for drills and hammer drills Choose the right bit While operating the hammer drill CAUTION • Choose the right bit for the work piece. • Use the auxiliary handles, if supplied with the tool. It reduces the risk of severe injury and makes the job easier. Loss of control may result in personal injury.
- Página 6 Parts Depth Impact-rotation control rod selector Handle Continuous use button Chuck Speed Rotation control selector Auxiliary lever handle Switch Handle Power Cord Power Protector cord Chuck Chuck wrench key holder Preparation Chuck assembly 1. Take the included chuck and fully open the jaws. 2.
- Página 7 Preparation Assembly 1. Turn the auxiliary handle clockwise while it is free, so that the opening of the frame passes freely over the drill bit. 2. Insert the rotary hammer head through the handle mount 3. Insert the depth control rod into the frame hexagonal orifice. 4.
- Página 8 Preparation Chuck Bit fitting • Put the bit into the chuck until it stops. Fasten with the chuck wrench and tighten alternatively the chuck into each of the orifices. WARNING Clean burrs and any other foreign objects from the drill bit and drill bit, otherwise the drill bit may not be tight and cause serious personal injury.
- Página 9 Maintenance Chuck replacement • Remove the auxiliary handle. • Open the chuck jaws all the way. • Using a screwdriver remove the left-threaded safety screw with a clockwise movement. • Fit the long side of an “L” Allen key (not included) in a vise .
- Página 10 Notes ENGLISH...
- Página 11 Authorized Service Centers In the event of any problem contacting a Truper Authorized Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers 800 690-6990 or 800-018-7873 to get information about the nearest Service Center.
- Página 12 Phone number ® 800-018-7873. Made in China. Imported by Truper, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257, Phone number 761 782 9100.