DHC BT2400 Pro Manual Del Propietário página 15

AMP CLAMP AND VOLT PROBE
(DC/AC Current and DC Voltage measurement)
Optional voltage probe MAX 40VDC (Base on the black clamp)
Optional current clamp MAX 600A (1A/1mV)
Note: Please use only the AMP clamp & Volt probe provided by DHC Specialty
Corp.
DC/AC CURRENT MEASUREMENT
1. Install the 9V battery.
2. Connect Clamp Meter to the jack A
on the tester.
3. Press the button ZERO. Make sure
the display reads zero.
4. Press the trigger to open the
transformer jaws and clamp one
electrical wire.
5. Make sure the clamp jaw is perfectly
closed.
6. Select "V/A METERS" from the main
menu.
7. Read the displayed value.
8. Select "Record Max" and then select "Stop Recording", the tester will display
the max current recorded during the recording period.
DC VOLTAGE MEASUREMENTS
*Do not test more than 60V, it may damage the tester.
1. Connect red test lead to the jack V on the tester.
2. Select "V/A METERS" from the main menu.
3. Use the test lead to touch a point within the network of the battery.
4. Read the displayed value.
15