DHC BT2400 Pro Manual Del Propietário página 4

4. If the battery is not sealed maintenance free, add distilled water in each cell
until battery acid reaches level specified by the manufacturer. This helps
purge excessive gas from cells. Do not overfill.
5. If it is necessary to remove battery from vehicle to test, always remove ground
terminal from battery first. Make sure all accessories in the vehicle are off to
ensure you do not cause any arcing.
OPERATION AND USE
Each time you connect the tester to a battery, the tester will run a quick cable
verification to ensure a proper connection through the output cables to sensors in
the clamp jaws. If the connection checks out OK, the tester will proceed to the
Home Screen. If the connection is poor, the display will show "CHECK CABLE".
In this case, check cable connections for visible signs of damage, as you may
need to re-connect the clamps to the battery or replace the cable end.
PAPER REPLACEMENT
1. Open the paper roll cover.
2. Place a new paper roll in the compartment. Make sure the thermal side is
upside placed as below.
3. Pull a short length of paper from the compartment and press down the cover
to close.
4