Publicidad
Maintenance
• Always disconnect the tool before cleaning it.
• Never use water or other liquids. Use a brush only.
• To prevent motor overheating clean regularly the ventilation slots.
• Double-check the entire tool components are perfectly tight.
• The tool housing shall not be cracked or damaged.
• Always verify the power cord is not cut or peeled.
• After a prolonged time of use, the grease in the head shall need to be
changed. Go to a
Repairs
Use only spare parts and accessories recommended by the manufacturer.
In the event the tool is not working take it to repairs in a
Authorized Service Center.
Carbon brush replacement
• Carbon brushes need to be replaced. Replace with new carbons when worn,
burnt, broken or smaller than 0.19" long.
• When replacing always replace both carbon brushes.
• Remove worn carbon brushes off the carbon housing. Remove accumulated
dust with compressed air.
• Set the new carbon brushes reversing the order. Carbons shall drop easily in
the carbon housing.
• After setting the new carbons run the car polisher a few minutes with no load
to get better fit.
• Use only original
specifically designed with the hardness and electric resistance for each type of
motor. Carbon brushes that are out of specification may damage the motor.
For best results it is recommended to use original accessories such as Truper´s
BOR-PULA-7N.
Storage
Neatly store the tool in a dry place and protected from dust and water .
Kickback and related warnings
• Kickback is the sudden binding or snagging of a rotating wheel, brush or other accessory. Jamming or snagging
causes rapid stalling of the rotating accessory which in turn causes the power tool to force itself in an uncontrolled
manner in the opposite direction of the accessory's rotation at the point of work.
• Kickback can occur as a result of misuse of power tools and/or improper operating procedures or unsuitable
conditions and can be avoided by taking the precautions outlined below:
• Maintain a firm grip on the power tool, keep your body and arm so that you can resist kickback (abrupt kickback)
forces.
• Always use the auxiliary handle; if provided, for maximum control over kickback or motor torque reaction during
start-up.
• The operator can control torque and kickback forces. If proper precautions are taken; • Never put your hand near the
rotating attachment. • The accessories can kick back on your hand.
• Do not put your body in the area where the power tool may move if kickback occurs.
• This drives the power tool in the opposite direction of the blade movement at the point of snagging or binding;
• Take special care when working on corners, sharp edges, among others. Avoid bouncing and jamming of the
accessory.
• When working around corners, sharp edges or bouncing can cause the accessory to jam and cause loss of control of
the power tool or kickback of the power tool.
Authorized Service Center to service it.
replacement carbon brushes
9
ENGLISH
Publicidad
