Publicidad
EN
2
BUILT-IN PHONO STAGE
The built-in phono stage is a high specification pre-amplifier. It is
designed to amplify the signal from a moving magnet cartridge to a
suitable level for all line level inputs of an appropriate system or audio
amplifier. This allows simple connection to a wide variety of products
using either the standard twin phono to phono lead (supplied) or phono
to 3.5 mm plug (not supplied).
Note: A 3.5 mm to phono lead must only be plugged into an appropriate
input. DO NOT CONNECT TO A HEADPHONE OUTPUT SOCKET (as found
on a mobile device or similar), as this could damage both the device
and player.
OUTPUT CONNECTIONS
Connect the output sockets of the built-in phono stage to a suitable
'line level' input on your amplifier using the appropriate phono leads.
IMPORTANT: Many amplifiers have a built-in phono stage. Never
connect the P1 Plus to an integrated phono stage. These are usually
marked 'Phono' or 'Disk' input.
IMPORTANT: Please turn down the volume on the amplifier before
switching the unit on or off.
OUTPUT CONNECTIONS
Note: Some amplifiers and all in one systems offer adjustable gain
settings. If this option is available, we recommend that the connection
used for the turntable is set to the lowest gain setting to avoid any
unnecessary background noise.
Note: When switching the P1 Plus on or off, a noise may be heard
through the speakers. This is the phono stage powering up momentarily
after the turntable. This is perfectly normal.
POSITIONING
As with any turntable, take care when positioning. Always place it on
a firm level surface. Never place the turntable on the same surface
as desktop or bookshelf loudspeakers as the energy created by the
loudspeakers can distort the music and affect performance. To
optimise performance, the turntable should be mounted on a hi-fi rack
or the dedicated Rega wallbracket.
PS1 (UK)
INPUT
230 V AC 50 Hz 0.07 A
OUTPUT
24 V AC 350 mA AC
PS1 (Korea)
INPUT
220 V AC 60 Hz
OUTPUT
24 V AC 350 mA AC
MADE IN ENGLAND
POWER CONNECTION
PS1 (EURO)
INPUT
230 V AC 50 Hz
OUTPUT
24 V AC 350 mA AC
PS1 (USA)
INPUT
115 V AC 60 Hz
OUTPUT
24 V AC 350 mA AC
www.rega.co.uk
POWER CONNECTION
Plug in the Rega PS1 350 mA power supply in to the wall socket. Set-up
is now complete. Simply switch on, sit back and enjoy!
WARNING
Only use the supplied mains adaptors with this product.
SERVICE
With the unit disconnected from the mains, only clean with a micro
fibre cloth (lightly damp if necessary). Do not remove any coverings;
there are no user serviceable parts inside. If the unit performs erratically
or emits smoke or odour, disconnect from the power supply and take it
to a qualified service technician.
WARRANTY
All Rega products are covered by a lifetime warranty against
manufacture defects. This warranty does not cover wear and tear. Any
unauthorised modifications or failure to follow the Rega recommended
guidelines may invalidate the warranty. If returning goods for inspection
to your retailer, the original packaging must be used to preserve the
warranty. Damage caused during transport due to incorrect packaging
may invalidate your warranty. Replacement packaging is available from
any Rega retailer. Your statutory rights are not affected.
PS1 (AUS/NZ)
INPUT
OUTPUT
PS1 (Japan)
INPUT
OUTPUT
v4
230 V AC 50 Hz 0.07 A
24 V AC 350 mA AC
100 V AC 50/60 Hz
24 V AC 350 mA AC
Publicidad
