LUND 78894 Manual Original página 10

PRODUCT OVERVIEW
The Hot Knife Cutter features a heated blade for effi cient and fast cutting of pol-
ystyrene-based materials. Diff erent types of blades allow both cutting and en-
graving foamed polystyrene. The tool is designed for household use only and
must not be used professionally, i.e. in workplaces or for paid work. Because a
correct, reliable and safe operation of the device depends on proper use, follow
the guidelines below.
Read and keep the entire Manual before the fi rst use of the tool.
The supplier shall not be held liable for any damage or injury resulting from im-
proper use of the tool, failure to observe the safety regulations or instructions in
this Manual. The use of the tool for purposes other than those intended in this
Manual shall void the user's rights under warranty and goods non-conformity.
ACCESSORIES
The product is delivered complete, but requires carrying out a number of prelim-
inary actions described in further sections of the Manual. The Hot Knife Cutter
comes with a thin wire blade stretched on a frame, a hot rod blade, an adapter for
engraving, and a stand for the safe setting aside the heated tool.
SPECIFICATION
Parameter
Catalogue No.
Rated voltage
Rated power
Heating Time
Weight
Protection class
Power supply
Rated voltage
Rated frequency
Output voltage
Output current
Weight
Protection class
GENERAL SAFETY CONDITIONS
Caution! Read all of the following instructions. Failure to do so may result in
electric shock, fi re, or personal injury.
FOLLOW THE INSTRUCTIONS BELOW
Do not use the product in an explosive environment containing fl ammable liquids,
gases, or vapours.
Before starting the product for the fi rst time, make sure that the product, its acces-
sories, and the power cord have not been damaged. If any damage is discovered,
it is not allowed to start working with the product. Any damaged components, in-
cluding the power cord, must be replaced at an authorized facility. It is not allowed
to repair the product on your own.
The product is intended for indoor use only. Do not expose the product to any
precipitation or moisture. If water and moisture enters the product, the risk of an
electric shock is signifi cantly increased. Do not immerse the product in water or
10
O R I G I N A L I N S T R U C T I O N S
GB
Units
[VDC]
[W]
[min]
[g]
[V~]
[Hz]
[VDC]
[A]
[g]
Value
78894
6
9
5 - 10
60
III
100-240
50 – 60
6
1.5
60
II