LUND 78894 Manual Original página 13

GB
Replacing the heating wire
If the cutting wire is deformed permanently, broken or there is too much dirt on it,
replace it with a new one. Replace the cutting blade only after it has cooled down
completely and the tool switched off and unplugged.
Use pliers to remove the whole worn wire. Be careful not to damage the wire
frame.
The ends of the frame come with grooves. Wind several coils of wire on the fi rst
groove. Then drag the free, longer end of the wire to the groove at the other end
of the frame and wound a few coils around it. Wrap the free ends of the wire
around the wire for approx. 1 cm (V) and cut off the rest with pliers.
O R I G I N A L I N S T R U C T I O N S
13