www.trapp.com.br
2 - Electrical safety
Do not expose the equipment (TR 200) to either
rain or humidity. Install the equipment in a dry
place, protected from weather conditions. Water
inside the equipment can damage the electric circuit
of the motor, besides increasing the risk of an electric
shock.
Before installing your TR 200, make sure the
electrical voltage in your property coincide with
the electric motor. Connecting electrical cables in a
different voltage will cause immediate motor
burnout resulting in a loss of warranty.
For your safety, ground the equipment. Failure to
do so may result in an accident, electrical shock or
personal injury.
3 - Personal safety
Beware with what is going on and use common
sense when operating the equipment. Do not use it
when you are tired, distracted or under the influence
of drugs, alcohol or medicine. A slight distraction
may result in a serious injury.
Do not leave shredder running and/or unattended.
Do not turn on shredder if feeding funel is open. In
this position the blades will lock.
Wear protection equipment. Always wear goggles.
Wearing protection equipment like gloves, shoes,
and ear plugs increases your protection and reduces
the risk of an accident.
Wear proper clothes. Wear neither loose clothes
nor jewelry.
Do not be self-confident. Keep both feet on the
ground to keep balance.
Take precautions against accidental running. Make
sure the switch (TR 200) is set to "off" before
plugging the equipment in. Failure to do so may
cause a serious accident.
Remove all objects before turning on the
equipment. A tool or any other object stuck in the
movable parts of the equipment may result in an
injury.
4 - Use and care
Do not overuse the equipment. Use it in the right
way and for the purposes described in this
manual for better performance and safety while
working.
Do not grind rock, glass, metals, plastics, chemical
products or other items that can damage the shredder
mill.
Should the shredder not achieve its full power
capacity, contact service dealer or an electrician to
verify the condition of your electric power source to
avoid motor burn-out by overload.
If after turning on shredder, motor does not start, turn
off immediately.
Verify that the blades are running counterclockwise.
Should blades be running clockwise, contact service
dealer or an electrician to invert direction of rotation
(TR 200).
Do not use the equipment if the switch does not
turn on/off (TR 200). The equipment can not be
controlled if the on/off switch is damaged. A
defective switch shall be immediately repaired.
Switch off the circuit breaker, remove the fuses or
unplug the equipment before servicing or
substituting the blades (TR 200). These safety
preventive measures reduce the risk of accidental
operation of the equipment.
Never put the equipment away with gasoline in the
tank (TR 200G). If necessary, keep the engine
running until it turns off due to lack of gasoline.
Fixing must be executed by authorized technicians.
Preserve your equipment. Frequently check if any
component is damaged or check for any other
condition that may affect its optimum operation.
Shall any problem arise, fix it before using the
equipment. Many accidents are caused by lack of
proper maintenance.
Keep the blades sharp and clean.
The blades keeps moving after the equipment is
switched off. Therefore be aware of that when
servicing.
Nota:
According to the Brazilian standard
NBR 5410, it is compulsory to install a device
to protect against residual differential current
(DR device) in the electrical installation.
The function of the "DR" is to protect the user
against serious electrical shock risk (consult an
electrician).
21