Publicidad
Idiomas disponibles
Idiomas disponibles
• Repeat the same procedure to fit the extender ducts into the support duct;
Extender duct
Pin
L-shaped slot
• After assembling the ducts, fit the joystick and screw it;
Duct
• Finally, fit the duct into the hose, and secure it with the clamp.
Hose clamp
Hose
To assemble the power cables on the joystick, follow the steps below:
• Remove the joystick cable cover, and turn on the connectors;
Support duct
Joystick
Screws
Screws
Joystick
cable
cover
• The 180° connectors belong to the battery cable and must be connected to
the cable harness connectors located on the joystick left side. Same color ca-
bles must be connected to same color cables;
180º connector
Battery cable
• The 90° connectors belong to the doser cable and must be connected to the
board metal terminals on the joystick right side. Each connector has the speci-
fic size of the terminal where it must be connected;
Doser cable
Metal terminals
• Before closing the joystick cable cover, position the cables so they are not
strangled or tensioned, and damaged;
• To close the cover, position the cable protector as shown in the image below;
Joystick
cable
cover
Cable
protector
• It is important to notice that on the inside of the cable protector, the wider
profile should be positioned downwards, in contact with the bottom of the
fitting. Otherwise, the cover will not fit properly;
Joystick
Cable harness
connector
90º connector
Screws
Wider
profile
21/43
Publicidad
