Descargar Imprimir esta página

Mattel Flying Ghast Instrucciones página 3

Publicidad

CHARGING THE GHAST
GHAST MUST BE FULLY CHARGED BEFORE FIRST USE. THE RED LIGHT WILL TURN OFF WHEN CHARGING IS COMPLETE.
1. Open the cover on the bottom side of the controller and take out the charging cable (see
2. Plug the charging cable firmly into the charging port on top of the Ghast (see
3. Connect the controller to a powered USB port with the supplied USB cable (see
4. To begin charging, flip the controller power switch from OFF (
A red light in the power switch will turn on.
This indicates the Ghast is charging. (see
5. The red light will turn off when charging is complete.
6. Hold the charging plug and gently pull it out of the port when charge is complete.
NEVER pull on the cable as this may cause the cable to break.
7. Replace the charging cable into the controller and close the cover.
8. Disconnect USB cable from the controller before play.
a
LiPo (LITHIUM POLYMER) BATTERY INFORMATION
• FULLY CHARGE THE BATTERY BEFORE STORING FOR AN EXTENDED PERIOD OF TIME (6 MONTHS OR LONGER).
PERIODIC CHARGING EVERY FEW MONTHS IS RECOMMENDED TO EXTEND BATTERY LIFE WHEN NOT IN USE. DO NOT
STORE NEAR HEAT OR IN DIRECT SUNLIGHT.
• DO NOT DISASSEMBLE THE GHAST'S PERMANENTLY INSTALLED LiPo (Lithium Polymer) BATTERY. IT IS A SEALED LiPo BATTERY. TO
PROPERLY RECYCLE, FOLLOW LOCAL LITHIUM POLYMER BATTERY RECYCLING GUIDELINES.
• DO NOT RECHARGE THE GHAST IF IT FEELS HOT. ALLOW IT TO COOL BEFORE RECHARGING.
• GHAST IS ONLY TO BE CHARGED USING THE CONTROLLER/CHARGER SUPPLIED. DO NOT CHARGE THE LiPo BATTERY IN ANY OTHER
BATTERY CHARGER.
• DO NOT ATTEMPT TO USE OR CHARGE THE GHAST IF IT SHOWS SIGNS OF LEAKAGE OR CORROSION.
• IF THE GHAST AND/OR CONTROLLER ARE WET, THOROUGHLY DRY BEFORE USING OR CHARGING.
• REGULARLY EXAMINE ALL WIRES AND CONNECTORS. IN THE EVENT OF DAMAGE, DISCONTINUE USE.
PAIRING THE GHAST WITH THE CONTROLLER
You must pair the controller with the Ghast before you can control it. FIRST SWITCH ON THE GHAST, THEN IMMEDIATELY FLIP THE CONTROLLER
POWER SWITCH TO ON (
). WAIT FOR A FEW SECONDS AND PUSH THE THROTTLE JOYSTICK ALL THE WAY UP THEN BACK DOWN, the
controller power switch light will change from flashing green to solid green when pairing is complete. If the green light does not stop flashing after a
few seconds, switch off the controller and Ghast and try again.
) to CHARGE (
d
).
b
a
).
b
).
c
).
).
c
3
d

Publicidad

loading