6. PERFORMANCE TIPS
REPLACING THE PROPELLERS
The Ghast comes with 1 extra set of replacement propellers (2 "A" propellers and 2 "B" propellers). If any of the Ghast's propellers break off or
become damaged, determine whether if it is the "A" propeller or "B" propeller that has to be replaced and replace them by following the steps below.
1. Use a coin (not included) to pry off the old propeller.
3. Align the pin to the hole of the propeller. Make sure the
molded letter (A or B) on the propeller is facing the shaft.
TROUBLESHOOTING
Q: The Ghast is not responding to the controller.
• Try recharging the Ghast or install new batteries in the controller.
• Turn off the Ghast and controller and pair them again.
• Radio interference can affect the Ghast's performance. Interference can be caused by other R/C vehicles running on the same frequency, electrical
wires, large buildings, WiFi or Bluetooth. If you experience interference, turn off the ghast and controller and relocate to a different area.
Q: The propellers are spinning but the Ghast does not takeoff.
• Check if the propellers are properly installed and match the correct A/B locations.
• Check the propellers for damage and replace any broken propellers with the spare set included.
• Increase the Ghast's throttle by pressing the up button on the throttle trim controls.
Q: The Ghast is flying out of control and drifting towards wrong directions.
• Adjust the FORWARD/BACKWARD or SIDEWAYS TRIM.
• For better control, make small, smooth and slow movements on the throttle and steering joysticks.
REPAIR & MAINTENANCE
• Use clear household tape to repair tears, creases or cracks. Use sparingly as added weight will affect performance.
• Dirt or mud on the Ghast can affect its operation. Use a clean, dry cloth to remove any dirt immediately. If the Ghast gets wet, turn it off and
allow it to dry completely overnight.
2. Select the required propeller
and match it to the rail with
the same letter. The
propellers with the same
letter (A or B) on them MUST
be diagonally across from
each other.
4. Use the coin to gently push the propeller onto the pin.
The coin will prevent the pin from poking your finger.
7
B
B
A
A
B
A
B
A
A
B
A
B