POLTI VAPORETTO SMART 100 Manual De Instrucciones página 12

followed and connect the accessories as
indicated in Section 2.
4.2 Connect the extension tubes to the steam
hose and the floor brush to the extension
tubes.
4.3 Attach the supplied
cloth to the floor brush. To
make it easier to attach, the
cloth
lock/release
avoid having to bend over
and use your hands. Just
place the cleaning side of
the cloth on the floor and rest the brush on
top.
4.4 Adjust the intensity of the steam by
turning the adjustment knob; for this type of
surface we recommend Medium level steam.
4.5 Deactivate the steam lock and continue
with steam delivery, pressing the steam
trigger on the handle of the steam hose.
4.6 Clean the floors by moving the brush.
The brush has a flexible joint that makes it
possible to reach the most difficult-to-reach
areas (under furniture, under beds, etc.).
The brush has bristles built
into the rear side ideal for
removing
stubborn
return the handle to the
vertical position locking the
brush, then tilt until the
brushes are touching the
floor and scrape off the dirt.
At the end of the cleaning operations, the
cloth can be removed from the brush by
pressing with a foot on the tab of the cloth
and pulling upwards on the extension tubes
connected to the brush.
Before removing the cloth from the brush,
wait a few minutes to allow the cloth to cool.
Do not use the appliance without the cloth.
For additional safety, test steam delivery on
a hidden area, leave the steamed area to dry
to ensure that no changes in colour or defor-
mations have occurred.
has an easy
system to
the most
dirt. To use,
| 12 |
5. CLEANING CARPETS AND RUGS
Before cleaning fabrics with steam, consult
the manufacturer's instructions and always
carry out a test on a hidden part or on a
sample of the material. Allow the steamed
part to dry to make sure that no changes in
colour or deformations have occurred.
5.1 Make sure that Section 1 has been
followed and connect the accessories as
indicated in Section 2.
5.2 Connect the extension tubes to the steam
hose and the floor brush to the extension
tubes.
Insert the brush with the
cloth attached (see point
4.3) in the special frame for
sliding on rugs.
5.3 Adjust the intensity of the steam by
turning the adjustment knob; for this type of
surface we recommend Medium level of
steam.
5.4 Deactivate the steam lock and continue
with steam delivery, pressing the steam
trigger on the handle of the steam hose.
5.5 Pass the floor brush over the surface.
Before removing the cloth from the brush,
wait a few minutes to allow the cloth to cool.
After which, remove the frame by resting the
foot on the relative symbol and then remove
the cloth by holding it firm with the foot
resting on the tab and pulling the brush up.
6. CLEANING GLASS, WINDOWS
AND TILES
To clean glass surfaces during cold weather,
preheat the windows starting to steam from
a distance of about 1.6 ft (50 cm) from the
surface.
6.1 Make sure that Section 1 has been
followed and connect the accessories as
indicated in Section 2.
6.2 Adjust the intensity of the steam with the
special handle; for this type of surface we
recommend Medium level of steam.
6.3 Ensure that the steam lock on the handle