Publicidad
Start up
Switch On
• Connect the plug into the power outlet.
• To start the tool, press switch (C) into the ON position ( I ).
• To shut off the tool, press the switch to the opposite side.
CAUTION
Do not start the tool when the sander surface is onto
the work piece.
CAUTION
Before shutting off the machine, keep it away from
the work piece.
Speed Control
• Depending on the job to be carries out, adjust the sanding speed
with the speed control (D).
This sander was designed to sand wood, metal, plastic
and similar materials. Can be used for repetitive sanding
jobs and finishing. Due to its size, is ideal for final jobs.
Sander Operation
• Switch on the sander before setting it onto the work
piece.
• Keep the sander base parallel to the work piece surface.
• Press lightly downwards onto the work piece. Make
circular movements. Be sure the full sanding area is
supported on the work piece.
• Ensure the pressure is moderated. Do not force the
sander. Make it work at a reasonable speed. If too much
pressure is applied, the motor speed could be slower due
to overheating. It could cause insufficient sanding and
damage to the motor.
• If after sanding, the surface is still showing marks, sand
again with a coarser grain to eliminate the marks. Replace
the sanding disc with the next one and finish sanding. Or,
replace the worn sanding disc with a new one.
• Do not let the sanding disc be totally worn out. Replace it
before this happens.
C
D
7
ENGLISH
Publicidad
