Markibar ORHI Manual De Instrucciones página 39

To replace the hopper, put the hopper stop (4) in its usual position (vertical line), by
pulling slightly and turning 90º. Insert the hopper until the stopper fits into the hole
(R) (see diagram in section 5.2). Tighten the screw (T) that attaches the hopper at
the back of the grinder
8.2.- Grinder exterior.
Clean with a damp cloth. Do not use detergents, abrasive products, alcohol or
solvents. Use a brush to clean the coffee from recessed areas.
The device must not be cleaned using a water jet.
9.- . Maintenance.
To ensure the efficiency and smooth operation of this grinder, follow the
manufacturer's instructions and ensure that any maintenance work is carried out by
qualified personnel.
It should be checked regularly so it continues to operate properly. The grinding
burrs in particular should be systematically checked at least once a year, and
replaced if worn, as the ground coffee quality will not be as desired.
K
mar
39