Publicidad
Step 10
Insert a SLIDE CAM (10A) into the DRAWER RIGHT SIDE (D133).
å
Diagram 1. Insert the tabs on a DRAWER STOP (20G) into the slots in an EXTENSION SLIDE (K). You may need to insert
å
one tab fi rst, then the other.
Diagram 2. Visually check that the DRAWER STOP (20G) is seated in the SLIDE (K).
å
Diagram 3. If the DRAWER STOP is not seated, use your hammer to gently tap the SLIDE until the tabs are properly seated
å
in the slots.
Now, fasten the EXTENSION SLIDE (K) to the DRAWER RIGHT SIDE (D133). Use two GOLD 5/16" FLAT
å
HEAD SCREWS (3S) through holes #1 and #3.
NOTE: The screw head in the CAM must be visible through the
å
slotted hole in the SLIDE.
Repeat this step for the other drawers.
å
1.
K
20G
These tabs must
insert into the slots.
Post
2.
K
20G
3.
Page 14
Slot
20G
Seated
1
K
2
3
D133
417244
Open end
Screw head - turn CAM to
line up holes in the SLIDES
with holes in DRAWER SIDES
10A
3S
GOLD 5/16" FLAT HEAD SCREW
(6 used in this step)
www.sauder.com/services
Publicidad
