Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 7
1. Bolt—M8 x 20 mm (2)
2. Washer—M8 (2)
6.
Insert the drag stake through the bottom opening
in the lower tail mount and secure it with the
lock pin.
Figure 8
1. Lockpin
7.
Install the drag stake handle assembly to the
drag stake.
Figure 9
g356257
3. Locknut—M8 (2)
g356254
2. Drag stake
g356436
2
Adding Oil to the Engine
Parts needed for this procedure:
1
Engine oil
Procedure
Important:
If the oil level in the engine is too
low or too high and you run the engine, you may
damage the engine.
1.
Move the machine to a level surface.
2.
Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
3.
Wait 3 minutes for the oil to settle in the engine.
4.
Wipe the dipstick clean with a clean cloth.
1. Dipstick
2. Full
5.
Insert the dipstick into the oil-fill tube, then
remove the dipstick.
6.
Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
4
through
6
is correct.
•
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
7.
Install the dipstick into the oil-fill tube securely.
8.
Recycle the used oil properly.
8
Figure 10
3. Add
(Figure
until the oil level on the dipstick
g334792
10).
Publicidad
