Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the Engine Oil
Changing the engine oil is not required, but if
you want to change the oil, use the following
procedure.
Note:
Run the engine a few minutes before changing
the oil to warm it. Warm oil flows better and carries
more contaminants.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
*There is residual oil in the crankcase after you drain
the oil. Do not pour the entire capacity of oil into the
crankcase. Fill the crankcase with oil as directed in
the following steps.
1.
Move the machine to a level surface.
2.
Refer to
Preparing for Maintenance (page
3.
Remove the dipstick by rotating the cap
counterclockwise and pulling it out.
Figure 18
1. Dipstick
2. Full
4.
Tip the machine onto its side (so that the air filter
is up) to drain the used oil from the oil-fill tube.
Figure 19
0.44 L (15 fl oz)*
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
15).
g334792
3. Add
g356437
5.
After draining the used oil, return the machine to
the operating position.
6.
Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7.
Wait 3 minutes for the oil to settle in the engine.
8.
Wipe the dipstick clean with a clean cloth.
9.
Insert the dipstick into the oil-fill tube, then
remove the dipstick.
10.
Read the oil level on the dipstick.
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8
through
10
is correct.
•
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11.
Install the dipstick into the oil-fill tube securely.
12.
Recycle the used oil properly.
16
until the oil level on the dipstick
Publicidad
